Screen a foot valve
Last Post 15 Dec 2017 10:34 PM by Russell Wiley. 4 Replies.
Author Messages
Thomas WentlingUser is Offline
Greenhorn
Greenhorn
Posts:4



--
04 Dec 2017 08:07 PM

    I just bought a used 2" Keene Dredge. I was wondering if I should put a screen around the foot valve, to reduce the hole size even more, or is putting it in a bucket good enough?

    JIM SHANNONUser is Offline
    Dredger
    Dredger
    Posts:93



    --
    05 Dec 2017 02:45 AM
    If you put a screen around it it would most likely clog up with fine trash.
    Putting it in a bucket would be better in shallow water because you don’t want to be sucking up a bunch of sand. If your in deeper water, just hang it from the dredge with a peice of rope so it’s not on the bottom. Check it for trash if you loose suction pressure
    Master Electrician----Brazos Bend Electric---Garrett Dealer
    Thomas WentlingUser is Offline
    Greenhorn
    Greenhorn
    Posts:4



    --
    05 Dec 2017 06:02 AM

    Thanks... My concern was loosing suction because of the screen. I saw on Youtube where guys put big screens around the foot valve to reduce the size of the stones that it would pick up

     

    WILLIAM HALLUser is Offline
    Lost Dutchman
    Lost Dutchman
    Posts:357



    --
    05 Dec 2017 03:20 PM
    Depending on the state your in, you may be required to add screen due to size openings.
    Either Oregon or Washington state (not sure which one) has a minimum opening size according to their req book
    Do your due diligence research to stay on the right side of Johnny Law.

    Bill
    So much river....So little time....Get out there
    Russell WileyUser is Offline
    Greenhorn
    Greenhorn
    Posts:11



    --
    15 Dec 2017 10:34 PM
    I think Jim Shannon has this one correct. A bucket in shallower water and hanging if in deeper water.

    Russ Wiley


    ---